Zebra ZM400 issue blank gap between words

Issues related to using NiceDrivers thermal printer drivers

Moderators: Georges, milos, NiceLabel Support Team

Post Reply
nicone93
Newcomer
Posts: 1
Joined: Fri Jul 17, 2015 5:03 pm

Zebra ZM400 issue blank gap between words

Post by nicone93 » Fri Jul 17, 2015 5:21 pm

Good day to all of the forum. I want to ask a question about a Zebra ZM400 label printer: sometimes prints some holes or gaps between words. You can fin a photo of issue here (http://tinypic.com/r/n227fs/8 or http://i61.tinypic.com/n227fs.jpg) and this was the code which generated that:

^XA
^MMT
^PW559
^LL0320
^LS0
^FB250,9,0,J,0
^FT260,197^A0N,20,19^FH\^FDlolololololololololololololololololollololololololololololololololololololololololololololololololololololololollololololololololololololololololololo^FS
^PQ1,0,1,Y
^XZ

Thank you in advance.

User avatar
Saso
NiceLabel
NiceLabel
Posts: 2961
Joined: Mon Sep 04, 2006 8:09 am
Contact:

Re: Zebra ZM400 issue blank gap between words

Post by Saso » Mon Jul 20, 2015 9:54 am

Your ZPL file prints fine on the RZ400 model with firmware version R53.16.6Z.

Could you share the label template (.LBL) you used to create the print file?
Which version of NiceLabel printer driver do you use?
Saso Fleiser
Senior Technical Product Specialist

Post Reply